Forum TI-Planet.org

Hello,
I know I had my Nspire CX working as a CAS model (on an older version)
but after going back to CX I don't seem to get it to work as a CAS again.
When setting the calc type to CAS in the ControlX boot menu (Ctrl+Reset, 8, 0)
my new settings are NOT saved and the calc boots normally.

Installed Versions:
OS: CX 4.5.4.48
CtrlX: 5.0.3
Boot: 4.50.14
My hardware is CR.

What am I missing?

Regards, Lars

you need boot2 4.4.0.8 , boot1.5 4.4.0.8 , use btmg put them in boot2 area , then ctrl+reset,ctrl+0,ctrl+8